Darkglass Electronics - Microtubes B7K V2 Bass Preamp Pedal
It's with great excitement that we can now announce STL Pro Audio is the new exclusive NZ distributor for Darkglass Electronics. This means ALL Darkglass Electronics products will available in NZ, with full support and warranties. Also at prices that can't be beat by parallel importing and with demos available in Wellington at our studio facility The Armoury.
Darkglass Electronics are a fantastic manufacture of boutique pedals and amplifiers and we are extremely proud to be representing them in NZ.
Darkglass Microtubes B7K V2 Bass Preamp Pedal
In stock and ships overnight for free!!
Bass Preamp Pedal with Deep Tone Editing
The Microtubes B7K V2 bass preamp pedal from Darkglass Electronics is so much more than an excellent DI. It's also a pedal-sized preamp and aggressive-sounding drive. The Microtubes B7K V2 employs the same dynamic saturation circuit and 4-band EQ and balanced line driver that has put Darkglass on thousands of bassists' boards. Yet, the addition of two mid-frequency selector switches, as well as the Grunt and Attack controls give the V2 unparalleled tonal shaping abilities. And dual outputs make parallel processing and running your signal to a PA or mixing console a piece of cake.
Deep Tonal Sculpting
The Microtubes B7K V2's 4-band EQ is powerful enough to place it on any bassists' board. But Darkglass has upped the game with their helpful Attack and Grunt switches, fine-tuning the pedal's character. But that wasn't enough tonal tweaking for the engineers at Darkglass. The V2 boasts two carefully voiced mid frequency buttons that determine which mid frequencies are being affected. Whether you're looking to pull the mids back for top-end attack and a huge bottom, or wanting to push them for a punchier tone, the Microtubes B7K V2 nails it.
Darkglass Electronics Microtubes B7K V2 Bass Preamp Pedal Features:
- Bass preamp pedal and DI box with saturation circuit
- 4-band EQ for shaping your tone
- Two mid-frequency selector buttons determine what mid frequencies are being affected
- Level knob sets the volume of your overdriven signal
- Drive knob controls the amount of saturation in your overdriven signal
- Blend knob adjusts the ratio between clean and overdriven signals
- Grunt switch dials in the amount of low-frequency saturation
- Attack switch tunes in the amount of high-frequency saturation
- Parallel output for parallel processing
- Direct output for running into PA systems and mixing consoles
http://www.facebook.com/mrexcane http://instagram.com/mrexcane The Darkglass Electronics Microtubes B7K Ultra analog bass preamp and overdrive. This pedal speaks for itself... it's amazing in every way. New features are three way toggle switches for each mid control, separate footswitch for the overdrive, master volume, and balanced DI output. Check out the entire Darkglass line of incredible creations: http://www.darkglass.com https://www.facebook.com/darkglasselectronics The Bass: MTD Michael Tobias Design 435 American maple burl top on poplar body with blueburst finish. Wenge neck and fretboard. The Amp: Mesa Boogie Carbine M9 into a RoadReady 6x10 cab. Speaker was mic'd with an AKG D112. There is no DI signal on this one. NO eq, audio controls, or compression were added. Enjoy \m/ #mrexcane
Darkglass Micr...http://www.facebook.com/mrexcane http://instagram.com/mrexcane...
Customers also viewed